Instruction manual

Bulletin 700-HXM
Plug-in Timing Relays
9-106
www.ab.com/catalogs Preferred availability cat. nos. are b
bold
.
Publication A117-CA001A-EN-P
0
1
2
3
4
5
6
7
8
9
10
11
12
13
Product Overview/Product Selection
 One of the world’s smallest preset digital timers
 Panel-mounted (1/32 DIN cut out)
 Built-in prescaling for counter operation
 Finger protection terminal block (VDE0106/P100)
 NEMA 4/ IP66
 User Manual 700-UM001_-EN-D available at Literature Library
Table of Contents
Product Selection...... this page
Accessories.................. 9-107
Approximate
Dimensions................... 9-112
Product Selection
See Specification table in this
section, page 9-107
Standards Compliance and
Certifications
Bulletin 700-HXM — Preset Counter/Timing Relay
Model Operating Modes
Counter Modes
1
Timing Range Counter Range Input Voltage Cat. No.Input Output
A mode: Signal ON-delay
B mode: Repeat Cycle
D mode: Signal OFF-delay
E mode: One Shot
F mode: Accumulative
Z mode: ON/OFF-duty
Adjustable Repeat Cycle
Increment
Decrement
Individual
Quadrature
N, F, C, K 0.000…9999 hr -999…9999 24V DC
700-HXM66SZ24
Cat. No 700-HXM...
1 For counter mode explanation, see page 9-109.
Level Key
Displays the present
value or parameter type.
When totalizing count is
displayed, the leftmost four
digits of the 8-digit
totalizing count will be
displayed (Zeros
suppressed).
Mode Key
Press this key to select
parameters within
each level.
Down Key
Each press of this key
decreases values
displayed on the No. 2
display. Hold down this key
continuously to decrease
values quickly. Also returns
setting items.
Up/Reset Key
Each press of this key increases values displayed on
the No. 2 display. Hold down this key continuously to increase
values quickly. Also advances setting items.
To reset the present value, press this key while the present value
is displayed. If this key is pressed while the totalizing count value is
displayed, the totalizing count value and the present value will be reset.
No. 2 Display
Displays set value
or set value of the parameter.
Displays the rightmost four digits
of the count value when the
700-HXM is used as a totalizing counter
(Zero suppressed).
Lit during reset using reset
input or Reset Key.
Lit when control output is ON.
Lit when totalizing value is displayed.
RST
OUT
TOTAL
Operation Display 2
Indicator
Meaning
No. 1 Display
Displays the present value or
parameter type. When totalizing count
is displayed, the leftmost four digits of the
8-digit totalizing count will be displayed
(Zeros suppressed).
Operation Display 1
Displays the time unit when
the timer function
has been selected
Example
5 h 30 min
123.4 s
General Timer Functions