Instruction manual

Bulletin 700-SH
Solid-State Relays
9-188
Approximate Dimensions
0
1
2
3
4
5
6
7
8
9
10
11
12
13
Mounting Considerations1‡§♣
All units are in mm's unless otherwise indicated. To convert to inches multiply by 0.0394. Dimensions are not intended for manufacturing purposes.
45.5
24.5
30.0
5.3
58.2
47.5
13.0
25
45.5
2 x M5
Screws
2 x M3
Screws
Cat. No. 700-SH5F…
Two Ø 4.4
or M4 Holes
Load
Power
Supply
Load
Load
Input
Terminal Arrangement/
Internal Connections
(Top View)
Mounting Holes
(Bottom View)
47.5
L1
T1
A2
A1
44.8
28.8
58.2 47.5
12.3
5.2
2 X M5
Screws
2 X M3
Screws
8.6
Operating
Indicator
APPLY
HEATSINK
COMPOUND
5.25
25
45.5
Two Ø 4.4
or M4 Holes
47.5
Cat. No. 700-SH10, -SH25, -SH50, -SH75, -SH100
1 The proper mounting orientation of the heat sink is so the heat fins run perpendicular to the floor (vertical) to maximize ventilation flow. If the fins do not run
perpendicular to the floor, a 30% current derating is required.
‡ When attaching a heat sink to Bulletin 700-SH, apply a thin layer of heat conductive grease (approximately 0.002 in. thick) on the heat sink to maximize heat
transfer between the SSR and the heat sink. Recommended types: Silicon based, Dow Cor
ning 340, Toshiba YG6240; Non-silicon based, AOS company type
53300 (Cat. No. 46801-010-01).
§ Tighten the SSR panel/heat sink mounting screws to a torque of 0.78…0.98 N•m (6.9…8.7 lb•in).
♣ Tighten the SSR terminal wiring screws as follows M4: 0.98…1.37 N•m (8.67…12.12 lb•in), M5: 1.57…2.35 N•m (13.89…20.8 lb•in).
www.ab.com/catalogs Preferred availability cat. nos. are b
bold
.
Publication A117-CA001A-EN-P