Instruction manual

Bulletin 900-CONV
Interface Controller
9-214
www.ab.com/catalogs Preferred availability cat. nos. are b
bold
.
Publication A117-CA001A-EN-P
Specifications
0
1
2
3
4
5
6
7
8
9
10
11
12
13
Specifications, Continued
General/Environmental Ratings
Insulation Resistance
20 MΩ min. measured at 500V DC between the following:
External terminals ↔ casing
RS-232C terminals ↔ RS-485 terminals power supply terminals
Isolation Method
Communications Phototransistor coupler
Power supply Isolating transformer
Dielectric Strength
1,500 V AC for 1 min. between the external terminal and case, and between the RS-232C
RS-485 block power supply terminal
Noise Immunity 500 V AC for 1 min. between the RS-232C/USB block and RS-485 block
Vibration (Max.) 10…55 Hz, 0.5 mm single amplitude for 10 min. each in X, Y, and Z directions (1 G)
Shock (Max.) 98 m/s
2
(10 G), 3 times each in X, Y, and Z directions
Weight Approx. 150 g
Enclosure Rating
Front Panel Operation Parts Conforms to IEC standards, equivalent to IP20 (when terminal cover mounted)
1
Terminals Equivalent to VDE 0106/100 (when terminal cover mounted)
1
Memory Protection
No protective functions (communications data is not protected for power interruptions
during communications)
EMC
Radiated Emission EN61326 class A
Conducted Emission EN61326 class A
Immunity ESD EN61000-4-2: 4 kV contact discharge (level 2); 8 kV air discharge (level 3)
Immunity RF-Interference
EN61000-4-3: 10V/m (amplitude modulated, 80 MHz…1 GHz) (level 3)
10V/m (pulse modulated, 900 MHz)
Immunity Conducted Disturbance EN61000-4-6: 10V (0.15…80 MHz) (level 3)
Immunity Burst EN61000-4-3: 2 kV power-line (level 3); 2 kV I/O signal-line (level 4)
Conformity to Standards
UL508, CSA C22.2 No. 14-95
Conforms to EN50081-2, EN50082-2, EN61010-1 (IEC 61010-1)
Conforms to VDE 0106/part 100 (Finger Protection), when the terminal cover is mounted.
1 When USB communication is used, the cover must be removed
Approximate Dimensions
Approximate dimensions are shown in millimeters unless otherwise indicated. Dimensions are not to be used for manufacturing purposes.
Cat. No. 900-CONVZ25
Mounting Hole Dimensions
(For Direct Mounting)
Two, M4 or 4.3 diameter holes
Note: DIN rail mounting is also possible.