Instruction manual

Bulletin 700-HLF
Interposing/Isolation Relays
9-56
www.ab.com/catalogs Preferred availability cat. nos. are b
bold
.
Publication A117-CA001A-EN-P
Specifications
0
1
2
3
4
5
6
7
8
9
10
11
12
13
Specifications
Cat. No. 700-HLF… (Relay Output)
Electrical Ratings
Pilot Duty Rating B 300, R 300
Rated Thermal Current (
I
th
)
1-Pole — 6 A
Rated Insulation Voltage (U
i
)
250V IEC, 300V UL/CSA
Contacts
Inductive 1-Pole
24V AC,
1-phase
30 A
5 A
120V AC,
1-phase
30 A 3 A
240V AC,
1-phase
15 A 1.5 A
Make, Break &
Continuous
V DC
24V DC 1.0 A
120V DC 0.2 A
240V DC 0.1 A
Inductive Load
AC-15 250V, 3 A N.O. Contact, 1.5 A N.C. Contact
DC-13 24V, 1 A N.O. and N.C. Contact
Min. Permissible Contact Ratings 12V, 6 mA (72 mW) for Silver Contacts, 8V, 2.5 mA (20 mW) for Gold Contacts
Permissible Coil Voltage Variation
Pickup: 85…110% of Nominal Voltage at 50 Hz
85…110% of Nominal Voltage at 60 Hz
80…110% of Nominal Voltage at DC
Must Dropout
Voltage:
10% of Nominal
Voltage at AC
5% of Nominal
Voltage at DC
Power Consumption
±10%
AC/DC 0.5 VA
Design Specification/Test Requirements
Dielectric Withstand Voltage
Pole to Pole
(VRMS)
1000V
Contact to Coil
(VRMS)
4000V
Input Voltage 24V AC/DC
Impedance (Ohms) 2 K
Mechanical
Degree of Protection IP20
Mechanical Life Operations 1 x 10
7
Electrical Life Operations
6 A Resistive: 100 000 min.
24V DC, 1 A Inductive: 200 000 min.
120V AC 1 A Inductive: 300 000 min.
Switching Frequency Operations (no-load) 10 cycles/sec
Coil Voltages See Overview/Product Selection
Timer Functions On-Delay, One Shot, Pulse and Flasher
Timer Settings 0.1...3 s, 3...60 s, 1...20 min, and 0.3...6 hr
Timer Adjustments Min and Max adjustments with Potentionmeter
Timer Accuracy Repeatability 1%, Recovery Time < 50 ms, Setting Accuracy Full Range 5%
Coil Surge Protection
Per EN 61000-4.5; Surge Immunity (801-5)
Class III: 2 kV common and 1 kV differential mode
Environmental
Temperature
Operating –40…55 °C
Storage –40…100 °C
Altitude 2000 m (6560 ft)
Construction
Insulating Material Molded High Dielectric Material
Enclosure Relay IP67
Contact Material
Silver Tin Ox., AgSnO
2
or Silver with Gold Plating, AgSnO
2
+ Au
Terminal Markings on Socket In accordance with EN50 0005
Certifications cULus Listed (File No. E3125, Guide NLDX/NLDX7) with Allen-Bradley socket, CE Marked
Standards EN60947-4-1,EN60947-5-1,CSA 22.2,UL 508,NEMA IEE MAC Compliant, ICS-2 Compliant
1 Performance Data – See this catalog, Important 3.
 Product shall be installed in an enclosure providing at least IP54 protection. Provisions shall be made to prevent the rated voltage fr
om being exceeded by
transient disturbances of more than 40%.