Specifications

3U Traffic Outstation Handbook
667/HB/26568/000 Page 119 Issue 15
9.6.6 Setting the Time and Date (CT)
12) 9.6.6 Set the time and date in the MOVA unit.
The unit may display its current time and date before displaying its main menu when
connection is first established with the MOVA unit, particularly after a mains power
failure or after being initialised. Alternatively, enter ‘CT’ from the MOVA main menu
to check the unit’s current time and date.
Time is 28/ 9/98 15:32:28
Do you want to change times <Y or N> ?
Typing ‘Y’ then ‘Return’ will allow the time and date to be changed. Any other
character (or ‘Return’ on its own) will be taken as ‘No’.
The time and the date must both be entered as 6-digit numbers, with a leading zero
for values in the range 1 to 9 and without any separators. For example:
Enter time [HrMnSc] 093700
Enter date [DyMoYr] 010998
Note that the new time is only accepted when the ‘Return’ key is pressed to enter the
date. Therefore the time entered should be 10 or 20 seconds ahead to allow time for
the date to be entered and then ‘Return’ can be pressed at the correct time.
After the new date and time have been entered, the current time is displayed again
so that it can be checked that it has been accepted correctly.
After the date and time, the summertime adjustment days in March and October can
be changed. Again, the values must be entered with a leading zero for dates in the
range 1 to 9.
Do you want to enter British Summer Time days <Y or N> y
Enter DAY in MARCH {2 digits - eg 01}, COMMA, DAY in OCTOBER [eg 23,15]
The unit’s clock can also be viewed and changed using the OMCU handset
command ‘TOD’, see page 183.
Tip!