Operation Manual

19
2. Put the cover back in place and screw it in.
3. Refit the appliance door.
Cleaning the rails
The rails can be removed for cleaning.
: Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
Detaching the rails
Note: Swing the front of the rail as far as possible (until you feel
resistance), because otherwise the appliance side panel may
become bent.
1. Carefully press the front of the rail upwards until it becomes
detached, and release it from the holder at the side (fig. A).
2. Detach the rail from the holder and remove it (fig. B).
3. Clean the rails with washing-up liquid and a sponge/brush
or
Clean the rails in the dishwasher.
Attaching the rail
1. Position the rail so that the indentations are facing upwards.
2. Hook the rail in at the back and push it towards the rear until
it engages (fig. C).
3. Hook the front of the rail onto the holder and press down until
it engages and is fixed level in place in the appliance once
more (fig. D).
Each set of rails only fits on one side.
Troubleshooting
Malfunctions often have simple explanations. Please read the
following instructions before calling the after-sales service.
Repairs may only be carried out by fully trained after-sales
service technicians. Incorrect repairs to your appliance may
present considerable risks for the user.
: Risk of electric shock!
■ Work on the appliance electronics may only be performed by
a specialist.
■ Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
%
$
'
&
Problem Possible cause Notes/remedy
The appliance does not work The plug is not plugged into the mains. Connect the appliance to the electricity
supply
Power cut Check whether other kitchen appliances
are working
Fuse defective Check in the fuse box to make sure that
the fuse for the appliance is OK
Faulty operation Switch the appliance off using the fuse in
the fuse box. Wait approximately
10 seconds and then switch it back on
Appliance does not start.
Nx ‹:…‹ min
appears in the display.
Cleaning aid or descaling was cancelled
Turn the operating mode selector to È or
calc and rinse the appliance twice
(see section "Cancelling the cleaning aid"
or "Cancelling descaling")
The appliance cannot be started The appliance door is not fully closed Close the appliance door.
The appliance is not in operation. A dura-
tion is shown in the display
A control knob was unintentionally
pressed
Press and hold the
† button
The
† button was not pressed after mak-
ing the setting
Press the † button briefly to start the
cooking operation, or press and hold the
† button to cancel the setting
Appliance does not start. A signal sounds A temperature outside of the possible tem-
perature range has been set
Check the temperature ranges for the
operating modes