Operation Manual

25
Replacing the cooking compartment bulb
Heat-resistant 230 V/25 W halogen bulbs with seals are
available from the after-sales service. Please specify the E
number and FD number of your appliance.
: Risk of burns!
Allow the cooking compartment and cooking compartment light
to cool before changing the bulb.
Always use a dry cloth to remove a new halogen bulb from the
packaging, otherwise it will not last as long.
1. Switch off the fuse in the fuse box or unplug at the mains.
2. Turn the cover anti-clockwise to remove.
3. Remove the bulb and replace with a bulb of the same type.
4. Slide the new seals and the clamping ring onto the glass
cover in the right order.
5. Screw the glass cover with the seals back on again.
6. Connect the appliance to the mains and reset the clock.
Never operate the appliance without the glass cover and seals.
Replacing the glass cover or seals
Any damaged glass cover or seals must be replaced. Please
provide the after-sales service with the E number and FD
number of your appliance.
Changing the door seal
If the seal around the outside of the cooking compartment is
faulty, it must be replaced. Replacement seals for your
appliance can be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
1. Open the appliance door.
2. Pull off the old seal.
3. Push in the new door seal at one point and pull it in all the
way round. The joint must be at the side.
4. Check again that the seal is correctly fitted in the corners.
Liquid in the evaporator dish has fully
evaporated, even though the water tank is
full.
The water tank has not been pushed in
properly
Slide in the water tank until it engages
The feed line is blocked Descale the appliance. Check whether the
water hardness range is set correctly
"Empty tank/clean?" appears in the display The appliance has not been used for at
least two days and the water tank is full
Empty and clean the water tank. Always
empty the water tank after cooking
There is a "pop" noise during cooking Cold/warm effect with frozen food, caused
by the steam.
This is normal
When you cook with steam, a lot of steam
is created
The appliance is being automatically cali-
brated
This is normal
When cooking with steam, a lot of steam is
produced repeatedly
The appliance is unable to calibrate itself
automatically if cooking times are too
short
Restore the appliance to the factory set-
ting (see section: Basic settings). Then
start steaming at 100 °C for 20 minutes
Steam escapes from the ventilation slots
during cooking
This is normal
The appliance is not producing steam
properly
Limescale has formed in the appliance Start the descaling programme.
Error message "E011" appears in the dis-
play
A button was pressed for too long or is
jammed
Press the
0 button to delete the error
message Press all of the buttons individu-
ally and check whether they are clean
An error message "E..." appears in the dis-
play
Technical fault.
Press the 0 button to delete the error
message. Reset the clock if required.
If the error message appears again, call
the after-sales service
The appliance is not heating. "Demo" is
shown in the display
A button combination was actuated Disconnect the power supply and recon-
nect after 10 seconds. Within 2 minutes,
press the
@ button for 4 seconds
Problem Possible cause Notes/remedy