Specifications

station.fm
A31003-H3590-M100-5-76A9, 11/2011
HiPath 3000 Manager E, Administrator Documentation
7-27
Nur für den internen Gebrauch Station view
Station Parameters
7.2.6 Station view: BRI (only in the USA)
You can use BRI to set the parameters for BRI stations.
CO/Protocol
This field allows you to choose the protocol for the BRI trunk line connected to the system. Pro-
tocols can be selected via the drop-down list .
SPID setup
When you order ISDN BRI primary directory service, your telephone company provides a SPID
(Service Profile Identifier) for all telephone numbers you have configured. The SPIDs are sent
with your ISDN order form.
The SPID has between 8 and 14 digits and acts as a terminal ID for the central office. The SPID
references a particular location in the CO memory where the relevant details of your service
are stored. You can enter up to two SPIDs per BRI line.
To enter the SPID numbers for each port, first select the slot/port in the drop-down list, and then
enter the SPID. For example, a SPID could include an area code, a prefix, a number, and a four-
digit suffix.
FIN for message waiting
The Feature Identification Number (FIN) is provided by your telephone company. Entering this
number in this field enables stations associated with ISDN primary directory numbers to receive
message waiting on and off commands from a CO-based voicemail system via BRI lines. This
field must be completed manually.
CAID or PDID setup
PDID (Phantom Direct Identifier) numbers are used with the DMS 100 protocol. CAID (Call Ap-
pearance Identifier) numbers are used with all other protocols. These numbers should be en-
tered in the fields provided.
CAID number corresponds to a "button" in your telephone company’s CO. This button is as-
signed to the DID number of a specific station. Up to 64 buttons may be configured for each
BRI line. Typically buttons one through forty-four are used for trunk lines. Buttons forty-five
through sixty-four are used for feature codes.
>
If no TMQ4 board has been configured, all fields of the BRI tab will be grayed out.