Specifications

Station view Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
7-28 HiPath 3000 Manager E, Administrator Documentation
station.fm
Station Parameters
Phantom numbers are used by the DMS 100 system for trunk lines. The PDID number is the
DID number for the station in question. You can specify the DID number for the station plus oth-
er numbers that should also be signaled if the first number is busy.
Each station can be assigned a maximum of four CAID or PDID numbers.
7.2.7 Station view: Template Editor
7.2.8 Station view: ISDN flags
You can use the ISDN flags mask to define protocols for the individual ISDN PRI or CorNet
lines listed under Trunks .
A description of the fields in the dialog box can be found under Trunks | Parameter/ISDN flags.
See also:
– Section 7.1, “Station Selection”, on page 7-2
– Section 7.2, “Station Parameters”, on page 7-3
7
For standard operation, no change in country-specific pre-settings is neces-
sary in the templates!
If you need to make changes to the templates in specific cases, note that you will
need to ensure the consistency of the modified data yourself!
See also:
– Section 7.1, “Station Selection”, on page 7-2
– Section 7.2, “Station Parameters”, on page 7-3
– Section 9.4.7, “Trunks | Parameter/Template Editor”, on page 9-73
See also:
– Section 7.1, “Station Selection”, on page 7-2
– Section 7.2, “Station Parameters”, on page 7-3
– Section 9.4.3, “Trunks | Parameter/ISDN flags”, on page 9-54