Specifications

settings03.fm
A31003-H3590-M100-5-76A9, 11/2011
HiPath 3000 Manager E, Administrator Documentation
9-53
Nur für den internen Gebrauch Settings Menu
Settings | Lines/networking
9.4.2 Buttons
Copy flags
Copy function with which the ISDN or main station interface (MSI) flags that were temporarily
stored for a line earlier using the Template button can be applied to any other line (see also the
Template button under Trunks | Parameter/ISDN flags).
Check
If the trunk codes are changed, the consistency of the codes isn’t checked until the Check key
is activated. Therefore, the codes can be entered into the table first and then a complete check
of the uniqueness of the codes can be implemented.
If consistency errors appear during the check, the codes that are not unique are displayed in a
separate window. The corresponding lines in the trunk table must then be corrected.
If you make changes to the trunk codes, you can perform a check to ensure that you have not
assigned any duplicate codes. If you have entered the same code for two trunks, the commu-
nication system displays a list of the duplications. You can then change one of the duplicate
codes so that each code is unique.
See also:
– Section 9.4, “Settings | Lines/networking”, on page 9-50
– Section 9.4.3, “Trunks | Parameter/ISDN flags”, on page 9-54
– Section 9.4.4, “Trunks | Parameter/MSI flags”, on page 9-62
– Section 9.4.5, “Trunks | Parameter/General Flags”, on page 9-66
– Section 9.4.7, “Trunks | Parameter/Template Editor”, on page 9-73
– Section 9.4.8, “Routes”, on page 9-74
– Section 9.4.9, “Routing parameters”, on page 9-83