Specifications

settings03.fm

A31003-H3590-M100-5-76A9, 11/2011

HiPath 3000 Manager E, Administrator Documentation

9-65

Nur für den internen Gebrauch Settings Menu

Settings | Lines/networking

With Release Monitoring flag

Normally, Groundstart COs offer release monitoring. For exceptional COs, where this is not the

case, this flag should be deleted. Transit connections are then monitored on a time basis and

cannot “hang” (same function as with Loopstart COs).

This flag is not used for non-groundstart COs. The display is arbitrary and should not be inter-

preted.

9.4.4.7 Area: Maintype

Here you select one of two CO signals to initiate a trunk seizure. You must select the appropri-

ate setting for the central office or the remote switch. The two signals are ground start, which

is the most common type of CO signal, and loop start, which is an older CO signal used prima-

rily with key systems.

Setting for TMANI/

TLANI:

Ground start or loop start.

Setting for TMGL: Ground start or loop start.

Setting for TIEL: E/M tie line with winkstart/delayed or E/M tie line with immediate dial.

Setting for TMDID: Direct inward dialing with winkstart/delayed or direct inward dialing

with immediate dial.

Setting for

T1 analog:

Ground start, loop start, E/M tie line with winkstart/delayed, E/M tie

line with immediate dial, Direct inward dialing with winkstart/delayed

or direct inward dialing with immediate dial.

Setting for TML8W: Default

For Austria protocol ÜFS

For IM with silent reversal