Specifications

Settings Menu Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
9-66 HiPath 3000 Manager E, Administrator Documentation
settings03.fm
Settings | Lines/networking
9.4.5 Trunks | Parameter/General Flags
General flags is used to define DISA options for ISDN lines.
To access the dialog box, double-click in the Param column in the Trunks tab and select the
General flags tab.
9.4.5.1 Area: Trunk, previous trunk, next trunk
This box shows the trunk code, card, slot number, and physical port of the selected trunk. The
individual slots/ports can be selected using the Next trunk and Previous trunk buttons.
9.4.5.2 Area: DISA day/night, None, Only night, Only day, Day and night
In the DISA day/night field, code receiver (CR) parameters can be configure for each line.
There are four options for DISA day/night service. You can allow full external access to tele-
phone features (such as voice mail and call forwarding) only when night service is active, only
when day service is active, or at both times. If you select none, the DISA function will be deac-
tivated.
One of the following options can be selected:
– None, line always has CR turned on
– Only night, line has CR connected only during the day
– Only day, line has CR connected only during the night
– Day and night, line without CR connection
To make sure the DISA settings are complete, you must also set the DISA DID number in the
Daylight saving time/DISA. You must also active the DISA class of service flag under Station
view: Flags.
Settings | Lines/networking | Trunks | Parameter | General flags
>
If DISA has been configured for an MSI line, this line can no longer be used for call
management.
No DISA flag may be set for MSI lines with DTMF DID since otherwise the DTMF is
stopped for this line. In this case, the DISA handling is completed in the same man-
ner as the direct inward dialing on ISDN lines.