Specifications

settings03.fm
A31003-H3590-M100-5-76A9, 11/2011
HiPath 3000 Manager E, Administrator Documentation
9-69
Nur für den internen Gebrauch Settings Menu
Settings | Lines/networking
9.4.6 Trunks | Parameter/TMANI Parameter
To display the "TMANI Parameter" tab, the TMANI card must be configured under System Sta-
tus | System-wide | Cards. The TMANI card provides interfaces for the analog trunk.
9.4.6.1 Area: Trunk, previous trunk, next trunk
This box shows the trunk code, card, slot number, and physical port of the selected trunk. The
individual slots/ports can be selected using the Next trunk and Previous trunk buttons.
9.4.6.2 Area: Frequency
In this area you can configure for the selected trunk the tones that can occur when a connection
is being established. To do so, select the tone in the "Frequency" selection box and assign this
tone the frequency value in the "Value" selection box.
Selection box: "Frequency"
Available for selection are:
Selection box: "Value"
Configurable for each tone (in Hz) are: 150, 330, 340, 350, 367, 400, 425, 433, 440, 450, 480,
520, 525, 600, 620, 800, 850, 900, 950, 1000, 1004, 1140, 1300, 1400, 1800, 2100, 300-500.
9.4.6.3 Area: Threshold
In this area you can define the voltage and current values as of which a signal is considered
"available" or "not available".
Settings | Lines/networking | Trunks | (double-click) column "Parameter"/
TMANI Parameter
Tone Default for "Value" (in Hz)
Frequency busy tone 440
PBX dial tone frequency 300-500
Special dial tone frequency 300-500
Dial tone frequency 1400
Tabelle 9-3 Tones and their default values in the "Frequency" area