Specifications

Settings Menu Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
9-178 HiPath 3000 Manager E, Administrator Documentation
settings07.fm
Settings | System Parameters
Automatic Customer Database Printout After Remote Administration
If this flag is activated, the customer database is automatically printed out on completion of re-
mote administration.
No. redial with a/c code
If this flag is set, besides the dialed call numbers, the account codes are also stored in the re-
dial memory of HiPath 3000. If a call number that was dialed together with an account code is
dialed again with the redial function, the communication system recognizes the account code
and the call number from the dialed digits.
If this flag is not set, only the dialed call numbers are stored in the redial memory of
HiPath 3000. If a call number is dialed again via the redial function, the communication system
requests an account code, if it was set for the affected route.
Automatic BRI Configuration (USA only)
If this flag is set, CACH numbers are set automatically. Manual setup of these numbers is then
no longer needed. This flag is automatically reset after the Automatic BRI configuration is
made.
Simplified Dialing
If the flag is activated, the trunk to the CO is automatically seized when the first digit of a call
number is selected and the call number entered is dialed. Dialing an access code (CO code,
seizure code) is not required. In order to call an internal station on the other hand, the following
must be performed:
● Either: Press the "Internal" key and then dial the call number of the internal station.
7
Trunk reservation is not possible in hands-free mode. In this case, the communica-
tion system interrupts call setup when it recognizes that the line is seized. A second
reservation overwrites the first.
Trunks cannot be reserved when LCR is active.
>
Important: This behavior is not supported for DECT handsets, because the redial
memory of the handset is used instead of the redial memory of HiPath 3000 for the
redial function, and HiPath 3000 cannot recognize the account code from the dialed
digits.
>
Important: If "Simplified dialing" (Prime Line) to the central office is activated, then
LCR ( Least Cost Routing) is not available. These features are not mutually compat-
ible.