Specifications

settings07.fm
A31003-H3590-M100-5-76A9, 11/2011
HiPath 3000 Manager E, Administrator Documentation
9-181
Nur für den internen Gebrauch Settings Menu
Settings | System Parameters
Display international / national code number
This flag is used to specify the display format for incoming calls that are saved in the SDS mem-
ory without a name. In the case of outgoing calls, the call number is always shown on the dis-
play as entered.
If this flag is not set, only the PABX number including the caller DID is displayed.
If this flag is set, the complete call number including the local area code is displayed.
Example 1:
An SDS with the call number: 06671234 is configured without a name.
02302 = prefix, 667 = PABX number, 1234 = extension
Behavior if the flag is not activated: SDS not shown. In the display: 06671234 is displayed. In-
coming call from 6671234. In the display: 6671234 is displayed.
Behavior if the flag is activated: SDS not shown. In the display: 06671234 is displayed. Incom-
ing call from 6671234. In the display: 023026671234 is displayed.
Example 2:
An SDS with the call number: 0023026671234 is configured without a name.
02302 = prefix, 667 = PABX number, 1234 = extension
Behavior if the flag is not activated: SDS not shown. In the display: 0023026671234 is dis-
played. Incoming call from 6671234. In the display: 6671234 is displayed.
Behavior if the flag is activated: SDS not shown. In the display: 0023026671234 is displayed.
Incoming call from 6671234. In the display: 023026671234 is displayed.
Line change for direct call
This flag is set for the USA by default, and is not set for all other countries.
If the flag is not set, consultation hold is initiated instead of line change. In the case of a line
change, the call takes place and can only be canceled at this terminal.
If the direct call is terminated by both subscribers, the MULAP line held switches to hold on both
sides.
Automatic redial
This system-wide flag defines whether or not automatic redial should be activated when a sta-
tion is busy. The timeout period after which automatic redial should be activated can be set with
Timer for automatic redial under Time parameters.