Specifications

Settings Menu Nur für den internen Gebrauch

A31003-H3590-M100-5-76A9, 11/2011

9-196 HiPath 3000 Manager E, Administrator Documentation

settings07.fm

Settings | System Parameters

Off-hook alarm time

If a subscriber lifts the receiver, the hotline is automatically called once the off-hook alarm time

has expired. However, this only happens if the subscriber does not enter any digits during this

time. The off-hook alarm time is specified in seconds.

If the hotline configured here is to be dialed directly after the receiver is lifted for a particular

station, the following must be observed:

● Correct setting, the hotline is called: The off-hook alarm time is "0" and the "Hotline" option

is configured at the same time for the station (Stationview: Activated features / Area:

Hotline / Hotline mode).

● Incorrect setting, the hotline is not called: The off-hook alarm time is "0" and the "Off-hook

alarm time" option is configured at the same time for the station (Stationview: Activated

features / Area: Hotline / Hotline mode).

Destination call number

A call number can be allocated to each hotline destination.

9.8.3.9 Area: DTMF pulse pause

The four options presented here allow you to select the appropriate pulse/pause ratio for a

DTMF system. These options define the duration of the DTMF tone sent to the public network.

In the USA, the standard setting is 70/70 ms.

9.8.3.10 Area: DID MFC-R2, Number

The number of DID codes can be entered in this field. This system-wide parameter is saved to

the loadware to ensure that the loadware can react to the CO in accordance with the protocol.

Possible digits are 1 to 6.

9.8.3.11 Area: Advisory call

This call only occurs if a MULAP is busy and a second MULAP is called. This call is offered at

a lower volume (which can be set on the terminal).

It is possible to differentiate between a Warning call (default) and a Normal call cadence.

TMANI/TLANI boards are reinitialized when this flag changes.