Specifications

settings07.fm
A31003-H3590-M100-5-76A9, 11/2011
HiPath 3000 Manager E, Administrator Documentation
9-197
Nur für den internen Gebrauch Settings Menu
Settings | System Parameters
9.8.3.12 Area: Toll restriction
Digit-by-digit is selected if the line should be seized directly. If you select Digit-by-digit, the
communication system sends the dialed number to the CO one digit at a time.
If you select en-bloc sending, the communication system waits until dialing is complete, and
then sends the number as a unit.
If you are using the LCR (Least cost routing) function, the en-bloc sending option must be se-
lected if required. With the en-bloc method, the line is only seized after positive digit evaluation
in the toll restriction Allowed/Denied List and/or after a time out.
9.8.3.13 Area: Cancel consultation
With analog telephones, a consultation call can be cancelled with Retrieve. Depending on the
option selected, the signal key is pressed either once or twice.
This feature allows users with non-display telephones to toggle between a caller and someone
to whom the call is to be forwarded, or to establish a conference call. When forwarding a call,
a user must first press the dial pulse (rotary) key and then dial the station number.
9.8.3.14 Area: Music On Hold
The Music On Hold feature allows you to choose among three possible options. The music for
this feature can be supplied internally or externally. The three available options are described
below:
Press signal key once If this option is selected, an analog extension which is in
consultation mode transferring the call to another exten-
sion and needs to return to the held line, must press the
consultation key once and wait for the timeout (standard
two seconds) to return o the held call. During the timeout a
feature access code, e.g., Conference, toggle can be acti-
vated.
Press signal key twice If this option is selected, an analog extension that is in con-
sultation mode transferring the call to another extension
and needs to return to the held line, must press the consul-
tation key once to activate a feature, e.g., Conference, tog-
gle. To return to the call on hold, the user needs to press
the consultation key again.