Specifications

settings07.fm
A31003-H3590-M100-5-76A9, 11/2011
HiPath 3000 Manager E, Administrator Documentation
9-223
Nur für den internen Gebrauch Settings Menu
Settings | System Parameters
Dial tone monitoring time
This is the waiting time for dialing tone. In case this timer
expires, the system assumes a failure of the trunk. The
trunk will be marked as "failed”.
Flash time for PBXs
(ineffective as of Hicom 150 E Office Rel. 1.0
SW version H)
(as of SW version H, this timer is set via Station view:
Template Editor)
Time for the signaling of the flash.
MOH delay timer
In case a connection is held, music on hold is applied, if
configured. However, MOH is only activated after this
time has expired, in order to make sure that activation of
features such as conferencing is not hindered by MOH.
(Call) hold 0 – 5 s
Pause before dial (only for Development)
If dial tone detection is not possible or desired for analog
trunks, dialing can be automatically initiated after this
time period.
Release if no dialing
In case of a trunk seizure and no dialing within a certain
time, the connection is released. The subscriber will get
busy tone.
5 – 30 s
Flash settling time (only for Development)
Time between trunk flash and transmission of dialing.
Dial pause length
This timer indicates the length of the pause to be imple-
mented between two digits, if a pause mark is detected.
1 – 5 s
Artificial end-of-selection
With external dialing, received digits after artificial end-of-
selection are interpreted as consultation hold.
5 – 15 s
Time parameters Effective in the
CP status:
Timer range