Manualshelf

Specifications

ManualsBrandsSiemens ManualsConsumer electronicsHiPath 3000 V3.0 or later Gigaset M1 Professional
551552553554555556557558559560
settings09.fm
A31003-H3590-M100-5-76A9, 11/2011
HiPath 3000 Manager E, Administrator Documentation
9-295
Nur für den internen Gebrauch Settings Menu
Settings | Network
9.10.1 Basic settings
The Basic settings are only valid as of HiPath 3000 V1.2. For other versions/variations, similar
settings can be made under IP parameters.
9.10.1.1 Area: IP access
Protocol
IP access is used to configure IP access in the communication system. Note that this IP access
has no significance for VoIP functionality, but only enables assess for administration, call
charge output and applications over CSTA.
The following protocols can be selected:
Block IP Access Manager
The IP Access Manager (see Start IP Access Manager handles the configuration of IP access
data of one or more communication systems (incl. the HG 1500 card) directly via the LAN. If
such direct configurations need to be prohibited due to special security requirements, this flag
must be set.
Settings | Network | Basic settings
Inactive There is no connection available to the communication system via IP.
LIM In this mode, the LIM sub-board on the control board is used as a LAN access
to the communication system (only HiPath 3000).
HIP In this mode, the HG 1500 card is used instead of the LIM sub-board as the
LAN access. The HG 1500 works in the bridging mode, that is, the HG 1500
and the central board of the communication system have separate IP address-
es that share a physical LAN interface.
SLIP In this mode, IP access is enabled via the V.24 interface. Either the router or
the CommServer (V.24/IP box) can be connected here.
This mode is currently used only in connection with HiPath 500, where HiPath
is connected with the HXGO card via a V.24 interface. The selection of this IP
access method sets default values for SLIP, which should generally not be
changed. SLIP is set by default for HiPath 3150 to 3250 On starting up the sys-
tem, a test (ping) is performed to verify that the IP connection is working. If it
is not, the V.24 interface is initialized with the with the usual V.24 parameters.