Specifications

Settings Menu Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
9-296 HiPath 3000 Manager E, Administrator Documentation
settings09.fm
Settings | Network
9.10.1.2 Area: Router call no.
Call no. test
The Call no. test is effective globally, i.e., if it is activated, only calls with a calling party number
for which there is also an ISDN partner (cf. routing) defined are accepted. All calls without a
calling party number are rejected.
Router call no.
The direct inward dialing of the communication system is specified here; this is the number un-
der which the communication system can be dialed from outside. The router functionality of the
communication system is accessible from outside under this direct inward dialing.
Check DID
The entered call number for the router is checked for consistency against the call numbers in
the communication system. The number must be unique.
9.10.1.3 Area: Connection control
Number redials
Gives the maximum number of Number redials for a call number from the PSTN partner struc-
ture (relevant only if the communication system initiates the call over PSTN).
Pause
Specifies the Pause, in seconds, between the number redials.
9.10.1.4 Areas: LAN interface/PSTN interface
The communication system is provided with 2 network interfaces. These are the LAN interface
(LAN), which is connected to the corporate network, and the Public Switching Telephone Net-
work (PSTN) interface.
The following parameters can be set up for both interfaces:
IP address
IP address of the interface.
>
The IP address must be unique within the network. Any new IP address to be con-
figured should therefore be "pinged" before it is assigned. If the IP address re-
sponds, it should not be assigned again.