Specifications

Settings Menu Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
9-300 HiPath 3000 Manager E, Administrator Documentation
settings09.fm
Settings | Network
9.10.2.2 Area: IP access
9.10.2.3 Area: Hicom 150 E Office
IP address
Enter the IP address with which the V.24/E board addresses the communication system. Nor-
mally, you select the default configuration for SLIP, i.e., 1.0.0.1 as the IP address.
Subnet mask
This field describes the subnet mask at the interface between the communication system and
the Com server.
MTU
This field shows the maximum Ethernet frame length on the highway between the communica-
tion system and V.24/E board. You should not change the preset value!
Inactive The connection from the V.24/E board to the communication system is
deactivated. The IP network access is then no longer available.
Slip Forwarding (The default setting for the IP access via V.24/E board (also called
COM server))
The IP address of the Com server is the same as the IP address for
the communication system. The Com server works in the transparent
mode, that is, all IP packets are forwarded to the IP protocol stack of
the communication system via SLIP.
SLIP Routing In this mode, the V.24/E board works as a router between the LAN and
SLIP interface. The IP packets are not forwarded transparently, but ac-
cording to the routing configuration.
HIP Forwarding In this mode, the HG 1500 is used as the LAN port instead of the V.24/
E. The HG 1500 works in the bridging mode, that is, the HG 1500 and
the main board of the communication system have separate IP ad-
dresses that share a physical LAN interface.