Specifications

Settings Menu Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
9-316 HiPath 3000 Manager E, Administrator Documentation
settings09.fm
Settings | Network
9.10.8 Firewall | Edit IP firewall
To edit the parameters, double-click the corresponding table cell Firewall.
Source IP addr.
The Source IP address to which the firewall should react. If this exact entry does not also turn
up in the IP routing table, the remote station is classified as an individual host. If a routing entry
exists for the IP address, the address type of the entry (network or host) is assumed.
Dest. IP addr.
The Dest. IP address determines the network or host to which a connection may be made. A
value of 0.0.0.0 authorizes a connection to any given IP address.
9.10.8.1 Area: Protocol
IP protocol
This setting allows the IP packet that should pass through the firewall to be more precisely
specified according to its protocol.
– All IP protocols
– TCP (Transmission Control Protocol)
– UDP (User Datagram Protocol)
– ICMP (Internet Control Message Protocol)
In order to be able to reach the applications in the communication system, the following table
must be taken into account on activating the IP firewall:
Settings | Network | Firewall | Edit IP firewall
Application IP protocol/IP port Command
Telnet TCP, Port 23
HiPath 3000 Manager TCP, Port 7000
CSTA TCP, Port 7001
Log UDP, Port 69 (TFTP) GET -i log.arc
APS (APS transfer) UDP, Port 69 (TFTP) GET, PUT -i Hicom.fli
Call detail recording UDP, Port 69 (TFTP) GET -i gez.txt, gel.txt, get.txt
CDB UDP, Port 69 (TFTP) GET -i kds.txt
ASCII UDP, Port 69 (TFTP) GET -i ascii.txt