Specifications

System Status Menu Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
10-28 HiPath 3000 Manager E, Administrator Documentation
status.fm
Call charges
Call detail recording per line (not in the USA)
Charges that accumulate on the trunk are output to the port that is set up.
MRATT (not in the USA)
Charges accumulated by call box users are signalled on the appropriate target port when an
MRATT Call charges key is set up. These charges can be viewed or printed out.
Customer Database Printout
This setting determines the port to which the printer is attached. Here you specify which V.24
interface should be used. This is the printer that will be used if you have elected to have the
database printout automatically after remote administration. (See also Flags).
Call info
In this field you specify which V.24 interface should be used for the Call Info output. This output
format is only relevant, if the On Ringing flag was activated.
LAN settings
As of Hicom 150 H V1.0 (Hicom 150 E Office Rel. 3.0), the call charges can be output via LAN
in 3 different modes. In this case, additional parameters can be set up under Output format |
LAN settings.
See also:
– Section 5.12, “Features for Call Detail Recording”, on page 5-27
– Section 9.4, “Settings | Lines/networking”, on page 9-50
– Section 9.4.13, “QSIG features (not in the USA)”, on page 9-98
– Section 9.8.1, “Flags”, on page 9-176
– Section 10.2, “Call charges”, on page 10-21
– Section 10.2.4, “Output format | LAN settings”, on page 10-29