Specifications

Starting up HiPath 5000 RSM/AllServe Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
4-16 HiPath 3000 Manager E, Administrator Documentation
allserve.fm
Settings for optiClient Attendant
4.3 Settings for optiClient Attendant
A number of settings must be made in HiPath 3000 Manager following the configuration of op-
tiClient Attendant. All station statuses can only be displayed network-wide if all six optiClient
Attendants are registered at an HLB.
4.3.1 Setting the Central busy signaling flag
The Central busy signaling flag must be set under Station view for the extensions in the other
nodes to be signaled at optiClient Attendant.
1. Select the Flags tab.
2. Activate the Central busy signaling option.
4.3.2 Entering a PABX number for the last route
The PABX number must be entered for the last route via Settings | Lines/networking |
Routes.
1. Make the relevant entries in the PABX number fields.
4.4 Information on Inter-system Busy Signaling
Information on Inter-system busy signaling must be entered via Settings | Lines/network-
ing | QSIG features.
1. Enter the node ID of the destination system in the Call no. target system field.
2. Enter the PABX number of the destination system in the Call no. target system field.
3. This PABX number must also be configured in LCR.
Topic
– Section 4.3.1, “Setting the Central busy signaling flag”, on page 4-16
– Section 4.3.2, “Entering a PABX number for the last route”, on page 4-16
>
Check if the value for Delay of busy signalling messages is set to 100ms under
Settings | System parameters | Time parameters.