Specifications

Starting up HiPath 5000 RSM/AllServe Nur für den internen Gebrauch
A31003-H3590-M100-5-76A9, 11/2011
4-28 HiPath 3000 Manager E, Administrator Documentation
allserve.fm
Central Busy Signaling with Attendant P
Setting up the PABX number in the node
Every node in a networked system has its own unique PABX number.
1. Select the menu item Settings | Lines/networking.
2. Select the Routes tab.
3. In the Routes list, select Trk Grp. 16 for HiPath 3000 and Trk Grp. 64 for HiPath 5000.
4. Enter the name of the route, e.g., LAN, in the Route Name field.
5. In the PABX Number Incoming area, enter the unique call number of the PABX in the
PABX number field.
6. Repeat steps 1-5 for each node.
Setting up the call number of the destination system
The call number of the target system need not be set up for the node at which Attendant P is
to be operated (in the sample configuration, Attendant P is operated at node 1). In all other
nodes (2-4), the call number must be set up.
1. Select the menu item Settings | Lines/networking.
2. Then select the QSIG features tab.
3. In the Inter-system busy signaling area, enter the value of node 1 in the System no. tar-
get system (here 1) and Call no. target system (here 9781) fields.
4. Repeat steps 1-3 for the other nodes.
Setting up the time parameter to delay central busy signaling messages
The time parameter for the “delay of busy signaling messages” need not be set up for the node
at which Attendant P is to be operated (in the sample configuration, Attendant P is operated at
node 1). For all other nodes (2-4), this time parameter should be set to 100ms.
1. Select the menu item Settings | System Parameters.
2. Select the Time parameters tab.
3. In the table for the Delay of busy signaling messages, select the value 100ms as the
base value.
4. Repeat steps 1-3 for the other nodes.