IP Phone User Manual

Operating the Telephone with the Display

Surviveability

If a HiPath 3000 fallback system was set up for your HiPath 8000,you will

still be able to use your telephone and the functions of the outage system

in case of e.g. a power outage.

If your telephone has no connection to the HiPath 8000, it will automatical-

ly connect to the HiPath 3000 fallback system. The message "Temporary

limited mode" is displayed.

While you are using the fallback system, the following functions are not

available:

• Call Forwarding ( page 43)

• Deflecting a Call ( page 27)

• Conferencing ( page 49)

• Voice Messages ( page 57)

• Reachability ( page 37)

• Callback ( page 36)

• Using Group Features ( page 60)

• Multiline Telephone – Introduction ( page 63)

• Call Display ( page 97)

• Transferring without Consultation ( page 32)

• Lock Phone with Forward ( page 115)

• Delay for Call Forward on No Reply ( page 99)

• HiPath 8000 Functions ( page 71)

Hot- and Warmline Function

Your service personnel can set up a hot or warm line for your or a specific

telephone.

If you pick up the receiver or press the loudspeaker key on this telephone,

the preset number is dialled

• immediately in case of a hot line;

• after a preset period of time in case of a warm line.

Examples:

• The elevator telephone is set to immediately dial the front desk’s tele-

phone number.

• The telephone next to an in-patient’s bed is set to dial the ward’s tele-

phone number after e.g. 1 minute if no other number is dialled.