Specifications
hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-17
Nur für den internen Gebrauch
Explorers
Basic Settings
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Basic
Settings > (right-click) Quality of Service > Edit Quality of Service Settings
The Quality of Service mask is displayed. You can edit the following data:
● Priority Class for Signaling Data: Select the relevant priority class for connection setup.
● Priority Class for Fax/Modem Payload: Select the relevant priority class for the fax and mo-
dem data of the IP connection.
● Priority Class for Network Control: Select the desired priority class for the network control
data (e. g. transfer of SNMP traps).
● Priority Class for Voice Payload: Select the desired priority class for the IP connection voice
data.
The various priorities are defined by means of AE/EF codepoints (see also Section 7.1.6.1,
"Display AF/EF Codepoints"). In addition, the following can be selected:
– CS7: The "Class Selector 7" (CS7) priority is used for network control packets
(for example, SNMP).
– Best effort: This priority is designed for typical router behavior.
● QoS Procedure: Select one of the following procedures:
– DiffServ: The transmission partner prefers to work with the evaluation of the "Differen-
tiate Services" 6-bit field (newer procedure).
– IP Precedence: The transmission partner prefers to work with the evaluation of the "IP
Precedence" 3-bit field (older procedure).
– Autodetect: Both "DiffServ" and "IP Precedence" are accepted for the evaluation.
Click Apply followed by OK in the confirmation mask (save the new configuration status perma-
nently with the Save icon in the control area).
7.1.8 SNTP settings
SNTP (Simple Network Time Protocol), described in RFC2030 (http://rfc.net/rfc2030.html), is
used for synchronizing the clocks on networked PCs. HiPath HG 1500 features an integrated
SNTP server, that can synchronize the time set on the clients with the time set on the board.
You can start, stop and configure the server.
>
In general, the preset values do not need to be changed.