Specifications

hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-29
Nur für den internen Gebrauch
Explorers
Security
7.2.1.3 Disable MAC Address Filtering
This option is only available if MAC address filtering rules have already been added (see Sec-
tion 7.2.1.4, "Add Rule for MAC Address Filtering") and MAC Address Filtering is enabled. You
can disable MAC filtering.
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Security
> (right-click) MAC Address Filtering > Disable MAC Address Filtering
A warning is displayed. Confirm this message with OK (save the new configuration status per-
manently with the Save icon in the control area).
7.2.1.4 Add Rule for MAC Address Filtering
This option allows you to create new rules for MAC address filtering.
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Security
> (right-click) MAC Address Filtering > Add Rule for MAC Address Filtering
A warning is displayed. Confirm this message with OK.
The Add Rule for MAC Address Filtering mask is displayed. You can edit the following fields:
● Rule Name: Enter a unique name for the filter rule in this field.
● For PPPoE Connection: If this check box is selected, this rule applies to PPPoE connec-
tions where the IP address is irrelevant because it is assigned by the provider. The MAC
address is essential for using this rule. The IP Address field is dimmed.
● IP address: In this field, enter the IP address from which IP packets should be accepted.
Please note that the filter will only accept packets from this IP address if the MAC address
also matches.
● MAC Address: In this field, enter the MAC address of the device from which packets should
be accepted.
If the device is connected via a router and not directly to the board, you must specify the
MAC address of the router. In this case, you must create another MAC filter rule consisting
of both the IP address and MAC address of the router. This process is necessary because
the router exchanges MAC addresses (that is uses its own MAC address) when transport-
ing the packets.
● Rule activated: If you activate this option, the filter rule just defined is immediately activat-
ed.
Click Apply followed by OK in the confirmation mask (save the new configuration status perma-
nently with the Save icon in the control area).