Specifications

hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-41
Nur für den internen Gebrauch
Explorers
Security
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Security
> (right-click) IP Administration Access > Delete All IP Addresses for Administration
A message appears. Click Delete, and OK in the subsequent confirmation mask.
7.2.4.4 Display State of Access Check
This option allows you to display an overview of all IP administration address access rights.
WBM path for WBM access:
WBM > Explorers > Security > (double-click) IP Administration Access > (right-click) Web-
based management > Display State of Access Check
WBM path for Telnet access:
WBM > Explorers > Security > (double-click) IP Administration Access > (right-click) Telne t >
Display State of Access Check
The IP Administration Access mask is displayed. This window specifies if Access Check is en-
abled for WBM or Telnet access (depending on your selection). Each IP address is listed in the
table below. This table also displays if the WBM or the Telnet Access Check is enabled for the
respective IP address.
7.2.4.5 Enable Access Check
If IP administration addresses have already been configured (see Section 7.2.4.7, "Add IP
Address for Administration"), you can enable the access check for permitted IP addresses.
WBM path for WBM access:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Security
> (double-click) IP Administration Access > (right-click) Web-based management > Enable Ac-
cess Check
>
If SSL is enabled (see Section 7.2.6.1, "Initial Configuration and Activation of SSL"),
the Telnet option is not available.