Specifications
hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-81
Nur für den internen Gebrauch
Explorers
Security
The Configured IPsec Rule mask is displayed. For descriptions of the individual fields, see Sec-
tion 7.2.5.64, "Adding rules".
Click Apply followed by OK in the confirmation mask (save the new configuration status perma-
nently with the Save icon in the control area). The Configured IPsec Rule mask remains visible.
7.2.5.67 Add Rule for Opposite Direction
If you have configured an IPsec rule for a transmission direction (see Section 7.2.5.64, "Adding
rules"), you should add the rule for the opposite direction directly afterwards. You can use the
"Add Rule for opposite direction" function to accept the entries for the selected rule. In this case,
the source and destination addresses are interchanged and the tunnel assignment is changed
accordingly.
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Security
> (double-click) VPN > (double-click) Rules > (double-click) Configured Rules > (right-click) se-
lected rule > Add Rule for Opposite Direction
The Add Configured IPsec Rule for opposite direction mask is displayed.
All rule parameters for the opposite direction match the rule for the transmission direction and
therefore cannot be edited. The priority for these two directions is also identical.
Click Apply followed by OK in the confirmation mask (save the new configuration status perma-
nently with the Save icon in the control area). The Add Configured IPsec Rule for opposite di-
rection mask remains visible.
7.2.5.68 Deleting rules
You can delete a configured rule (see Section 7.2.5.64, "Adding rules").
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Security
> (double-click) VPN > (double-click) Rules > (double-click) Configured Rules > (right-click) se-
lected rule > Delete Rule
A warning is displayed. Click Delete followed by OK in the confirmation mask (save the new
configuration status permanently with the Save icon in the control area).
>
You can edit the priority of an existing rule. However, the connection is cleared down
when you apply the change if this rule was in use while you were editing it.
You should leave spaces between the assigned priorities to enable new rules to be
added easily between existing rules if required. We recommend defining priorities in
steps of ten or one hundred.