Specifications

Explorers Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
7-88 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-07.fm
Security
The logon page opens. Log on by entering the user name and password. For example, you
can use the access data that you entered for the V.24 Interface. If other user names and
passwords have been set, you can use one of the passwords configured.
15. Check whether the certificate you created is listed in WBM (SSL > Certificate Management
> Server Certificates). It should be the only certificate in this list and should be activated.
The board is now in secure administration mode.
Follow-up steps:
You can now configure the board. First run the initial setup wizard (see Section 5.1, "Initial Se-
tup").
The Certificate Generation function is available for creating the SSL CA certificate or further
SSL server certificates, (see Section 7.2.6.3, "Certificate Generation").
The Certificate Management function is available for administering generated certificates (see
Section 7.2.6.11, "Certificate Management").
A download function is available for saving the SSL configuration (see Section 6.1.2.1, "Load
from Gateway").
7.2.6.2 Reset to insecure mode
All security-specific data (for example, all certificates and services and rules which you created
yourself) is deleted when you disable the VPN and SSL functions and revert to insecure mode.
If you did not save this data previously (see Section 6.1.2.1, "Load from Gateway"), then you
will need to create it again when you revert to secure mode.
If you deactivate the VPN and SSL functions, the system reverts to the HTTP protocol. The In-
ternet Explorer – which communicates via HTTPS in secure mode – immediately looses ac-
cess to the board. The connection must be reestablished in the Explorer address bar. Use the
HTTP protocol and port 8085 to do this.
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Security
> (right-click) SSL > Reset to insecure mode
An important warning is displayed. Click Activate Now followed by OK in the confirmation mask.
The board now automatically performs a restart.