Specifications
hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-105
Nur für den internen Gebrauch
Explorers
Network Interfaces
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Network
Interfaces > (right-click) LAN1 (LAN1) > Edit LAN1 Interface
The LAN1 mask is displayed. You can edit the following fields:
● Interface Is Active: Select this option if you want to activate this interface.
● IP address: Specify the IP address of the interface in this field.
● IP Netmask: Specify the subnet mask in this field.
● The MAC address of the LAN1 interface is displayed here for information purposes.
● Ethernet Link Mode: Select the operation mode for the LAN interface from the context
menu:
– Auto: automatic switching between 10 and 100 Mbps and half duplex and full duplex
mode
– 10HDX: 10 Mbps, half duplex
– 10FDX: 10 Mbps, full duplex
– 100HDX: 100 Mbps, half duplex
– 100FDX: 100 Mbps, full duplex
● Maximum Data Packet Size (Byte): Enter the maximum packet length in bytes that should
apply for this IP protocol. Values between 576 and 1500 are permitted.
● QoS Capability of Peer: Select one of the possible settings from the context menu (see also
Section 7.1.7, "Quality of Service"):
● IEEE802.1p/q Tagging: This option can be used to set the Ethernet format that is sent by
the board. The option is normally deactivated.
– IEEE802.1p/q VLAN ID: Enter a value that differs from the default value "0" as the
VLAN’s ID number if the switch used has problems with the default value "0".
– Data traffic: Enter a value for the priority of the layer 2 QoS class "Data Traffic". Values
between 0 and 7 are permitted. Default = 0.
>
The interface partners must be identically configured to guarantee LAN func-
tionality.
>
The following fields are only shown when IEEE802.1p/q Tagging is activated.