Specifications
Explorers Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
7-108 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-07.fm
Network Interfaces
Selected connection type: LAN2
If you have selected LAN2 in the field Use the Second LAN as, you can edit the following fields:
● IP address: Specify the IP address of the interface in this field.
● IP Netmask: Specify the subnet mask in this field.
● The MAC address of the LAN2 interface is displayed here for information purposes.
● Ethernet Link Mode: Select the operation mode for the LAN interface from the context
menu:
– Auto: automatic switching between 10 and 100 Mbps and half duplex and full duplex
mode
– 10HDX: 10 Mbps, half duplex
– 10FDX: 10 Mbps, full duplex
– 100HDX: 100 Mbps, half duplex
– 100FDX: 100 Mbps, full duplex
● Maximum Data Packet Size (Byte): Enter the maximum packet length in bytes that should
apply for this IP protocol. Values between 576 and 1500 are permitted.
● Network Address Translation: Select this option if you want to activate the function for
masking private (internal) IP addresses.
● QoS Capability of Peer: Select one of the possible settings from the context menu (see also
Section 7.1.7, "Quality of Service"):
● Bandwidth Control for Voice Connections: Bandwidth control can be used to ensure that a
guaranteed level of bandwidth is available for voice connections (as a percentage of the
entire bandwidth available for the connection). This means that data-only transmissions,
for example, cannot fully use the uplink function to the Internet over LAN2. Select the
checkbox if you want to activate the "Bandwidth Control for Voice Connections" function.
● Bandwidth of Connection (Kbps): Enter the bandwidth of the connection in kilobits per sec-
ond.
● Bandwidth Used for Voice/Fax (%): Specify the percentage of bandwidth that should be
used for voice/fax connections.
● IEEE802.1p/q Tagging: This option can be used to set the Ethernet format that is sent by
the board. The option is normally deactivated. The following fields are only shown when
IEEE802.1p/q Tagging is activated.
>
The interface partners must be identically configured to guarantee LAN func-
tionality.