Specifications

hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-109
Nur für den internen Gebrauch
Explorers
Network Interfaces
– IEEE802.1p/q VLAN ID: When the IEEE802.1p option is active, you can enter a value
that differs from the default value "0" as the VLAN’s ID number if the switch used has
problems with the default value "0".
– Data traffic: Enter a value for the priority of the layer 2 QoS class "Data Traffic". Values
between 0 and 7 are permitted. Default = 0.
– Signaling data: Enter a value for the priority of the layer 2 QoS class "Signaling data“.
Values between 0 and 7 are permitted. Default = 3.
– Voice/Fax/Modem Payload: Enter a value for the priority of the layer 2 QoS class
"Voice/Fax/Modem Payload“. Values between 0 and 7 are permitted. Default = 5.
– Network control: Enter a value for the priority of the layer 2 QoS class "Network Con-
trol". Values between 0 and 7 are permitted. Default = 0.
Click Apply followed by OK in the confirmation mask (save the new configuration status perma-
nently with the Save icon in the control area).
Selected connection type: DSL Connection Type PPTP
If you have selected DSL Connection Type PPTP in the field Use the Second LAN as, you can
edit the following fields:
IP Parameters:
● Remote IP Address of the PPP Connection: Enter the IP address of the remote end of the
PPP connection in this field. If this PPP connection is used for Internet access, this entry
is only necessary if the Internet Service Provider uses a static IP address.
● Local IP Address of the PPP Connection: Enter the IP address of the local HXG3 board in
this field. If this PPP connection is used for Internet access, this entry is only necessary if
the Internet Service Provider assigned you a static IP address.
● Maximum Data Packet Size (Byte): Enter the maximum packet length in bytes for the IP
protocol. The permitted range of values goes from 576 to 1500 bytes.
● Negotiate IP Address: Select how the connection partners should negotiate the IP address
at connection setup.
General PPP Parameters:
● Default Router: Activate this option if you want to use the DSL connection configured here
as a routing destination. Please note that you can only have one default router: this is either
the DSL access configured here or an individual PSTN peer – see also Section 7.4.4,
"PSTN".
● Internet Access with DNS Request: Specify if you want to use the access for Internet ac-
cess. Note that only one Internet access may be activated per HiPath 3000/5000 V8 - HG
1500 V8 (either one PSTN peer or one DSL connection).