Specifications

hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-113
Nur für den internen Gebrauch
Explorers
Routing
WBM path:
WBM > Explorers > Network Interfaces > (double-click) LAN2 ([not used]) > (right-click) > Edit
ACD
The ACD Configuration mask is displayed. You can edit the following fields:
● Force Reconnect at: In these three fields, you can specify a time of day at which the con-
nection will be severed and reestablished automatically. Enter the hours in the first field,
the minutes in the second field and the seconds in the third field. Entering 15:30:00, for ex-
ample, will cause the connection to be severed and reestablished at 15:30 every day.
The following field is displayed for verification:
● Connection Time: hours, minutes and seconds elapsed since the last connection was sev-
ered and reestablished automatically.
When all settings are complete, click Apply followed by OK in the confirmation mask (save the
new configuration status permanently with the Save icon in the control area).
7.4 Routing
In small networks, a routing table can be set up manually on every router by the network ad-
ministrator. In larger networks, this task is automated with the help of a protocol that distributes
routing information in the network.
An IP packet can transit many routers before it reaches its destination. The route it takes is not
defined centrally, but by the routing tables in the individual routers along the way. Each router
only establishes the next step on the path and relies on the next router to forward the packet
correctly.
In HG 1500, you can configure IP routing, IP mapping, NAT, PSTN routing and SCN routing.
WBM path:
WBM > Explorers > Routing
The Routing tree structure is displayed.
Entries under Routing:
> IP Routing
> IP mapping
> NAT
> PSTN
> Dialing Parameters