Specifications

hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-121
Nur für den internen Gebrauch
Explorers
Routing
7.4.1.19 Executing Traceroute
You can start the Traceroute command to test the routing function.
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Routing
> (double-click) IP Routing > (double-click) ICMP Request > (right-click) Traceroute > Execute
Traceroute
The Traceroute mask is displayed. You can edit the following fields:
Destination Address: Enter the IP address of the destination. The traceroute between the
HG 1500 and this destination address is determined.
TOS Byte: Specify whether TOS bytes (TOS = Type of Service) are to be sent. TOS bytes
provide information on the quality of a service.
Click Send or Send (in a separate window).
The result of the traceroute request is displayed.
The following buttons are provided in the output area:
Smaller reduces the font size in the output.
Bigger increases the font size in the output.
Reload repeats the traceroute request.
7.4.2 IP mapping
This function allows you to configure up to 20 IP address pairs. With these specifications, IP
addresses are exchanged between the internal LAN and the (external) interface when perform-
ing routing with appropriately parameterized partners at the PPP or DSL interface (IP mapping
enabled).
As a result, multiple IP networks with the same addresses, for example, can be reached if these
networks are accessed via a HG 1500.
WBM path:
WBM > Explorers > Routing > IP Mapping
Right-click IP Mapping to display a menu containing the following entries:
> Display IP Mapping Netmask
> Edit IP Mapping Netmask
> Adding an IP map
> IP Map Table Editor