Specifications

hg-02.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
2-1
Nur für den internen Gebrauch
Preparing the Board
Starting the HG 1500
2 Preparing the Board
Notes on how to install the HG 3550/3540 V2.0 may be found in the corresponding AMO STMIB
service manual or the HiPath 4000 HiPath Manager.
Once the HiPath HG 1500 has been installed, it must be started and configured for HTTP ac-
cess via WBM. The start-up procedure and configuration options are described in this chapter.
2.1 Starting the HG 1500
When the system is started, the HiPath HG 1500 is automatically started as well. This initiates
the firmware start routine, the gateway self test and the startup procedure.
2.1.1 Firmware Start Routine
The firmware is located in the flash memory and is started each time the system is rebooted.
The firmware code resets the system and is the first code to be run when the power supply is
switched on.
The firmware performs the following functions:
1. Initializes the hardware components of the board.
2. Tests the hardware components (Built-In Self-test BIST).
3. Creates the file system in the flash memory.
4. Activates the CLI handler).
5. Loads data from the flash memory (loading program).
6. Starts the application program.
The automatic boot procedure between steps 4 and 5 and can be interrupted, as described in
Section 2.1.3, "Interrupting the Boot Procedure".
If the boot procedure is not interrupted, the gateway continues the boot procedure and can then
be configured.
>
If you are using the HiPath HG 1500 for an Internet connection:
An Internet connection always involves an elevated security risk. In order to keep
risks to a minimum, we therefore recommend installing and using a security solution
that satisfies security requirements.