Specifications

hg-02.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
2-3
Nur für den internen Gebrauch
Preparing the Board
Configuring the HiPath HG 1500
2.2.1 Configuration via CLI Interface
Configuring CLI:
1. Connect a serial terminal or a PC with a VT 340 terminal emulation program (e.g. Hyper-
Teminal) to the HiPath HG 1500 V.24 interface.
The connection requires the following settings:
Baud rate: 19200, Data: 8 bit, Parity: none, Stop bits: 1, Data flow control: none.
2. Start the HiPath 3000 system.
3. Press any key to display the please log in prompt. Log on by entering the user name
and password. The user name and password are specified in the HiPath 3000 system us-
ing HiPath 3000 Manager E.
4. Activate the write access:
get write access
If the command is correct, OK is displayed.
The same applies to all subsequent entries.
Assigning an IP address to the HiPath HG 1500 LAN1 interface:
1. Set up the gateway IP address (LAN1 interface) by entering the following:
set ip address xxx.xxx.xxx.xxx
where xxx.xxx.xxx.xxx is the IP address (number).
2. Set up the subnet mask for the gateway by entering:
set ip subnet yyy.yyy.yyy.yyy
where yyy.yyy.yyy.yyy is the address mask.
Example of a Class C subnet:
255.255.255.0
Saving entries and rebooting the HiPath HG 1500:
1. Save the configuration by entering the following:
save configuration
2. Start the gateway by entering:
reset