Specifications

hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-187
Nur für den internen Gebrauch
Explorers
Payload
7.7.2.2 Changing parameters
This option allows you to edit the current settings for QoS Data Collection.
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Payload
> (right-click) QoS Data Collection > Edit Parameters
The Quality of Service Data Collectionmask is displayed. You can edit the following fields:
QDC configuration
● Send to QCU: Enable this checkbox if you want to send data to the QCU.
Default value: Checkbox disabled.
● QCU IP Address: Enter the IP address or the name of the QCU host here.
Default value: 0.0.0.0.
● QCU Receive Port: Receive port for QCU. Enter the port number for the QCU host here.
Default value: 12010.
● Send to Network Management enabled: Enable this checkbox if you want to send data to
the Network Management system.
Default value: Checkbox disabled.
QDC report mode
● Send Report if: Select the send time for the report from the list box. The following options
are available:
● do not send: No reports are sent.
● End of session and threshold exceeded: A report will only be sent at the end of a ses-
sion and only if the threshold is exceeded.
● End of report interval and threshold exceeded: A report will be sent for each report in-
terval once the threshold has been exceeded.
● Report Interval (sec): Enter the interval (in sec.) at which the reports should be sent. A QoS
report will be sent for each report interval if the report mode is set correspondingly.
Default value: 60 sec.
Valid values: 0 ... 65535
● Observation Period (sec): This parameter cannot be adjusted.
Default value: 10 sec.
>
If either of the check boxes Send to QCU or Send to Network Management is en-
abled (checked), QoS reports will be generated.