Specifications

Explorers Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
7-188 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-07.fm
Payload
● Minimum Session Length (* 100 msec): Enter the minimum session length (* 100 msec)
here. A QoS report will not be sent if a session (for example, a call) is shorter than the set
minimum value.
Default value: 20 (2 sec)
Valid values: 0 ... 255
QDC threshold values
● Upper Jitter Threshold (msec): In this field, enter the upper threshold value for report gen-
eration. The jitter is checked to monitor if this threshold has been exceeded and is mea-
sured in the time between two consecutive RTP packets.
Default value: 20 msec
Valid values: 0 ... 255
● Average Round Trip Delay Threshold (msec): Round trip delay reflects the total runtimes
in both directions. In this field, enter a threshold value for the average round trip delay that
results in report generation.
Default value: 100msec
Valid values: 0 ... 65535
● Thresholds for Compression Codec: In this field, enter the required number of packets for
the compression codec thresholds. The following options are available:
● lost packets (per 1000 packets): In this field, enter a threshold value for the packets
lost during voice decoding. This value represents the packet loss in relation to the total
number of packets.
Default value: 10
Valid values: 0 ... 255
● consecutive lost packets: In this field, enter a threshold value for consecutive lost pack-
ets. The number of consecutive packets lost (uninterrupted by "good" packets) is
counted. If the value counted is greater than the value specified, the threshold has
been exceeded.
Default value: 2
Valid values: 0 ... 255
● consecutive good packets: In this field, enter a threshold value for consecutive good
packets. The number of consecutive "good" packets (uninterrupted by lost packets) is
counted. If the value counted is less than the value specified, the threshold has been
exceeded.
Default value: 8
Valid values: 0 ... 255
>
The time scale is segmented during the observation period and the report interval.
Each observation period is checked to monitor if the threshold has been exceeded.
A QoS report will be sent for each report interval if the corresponding report mode
setting is enabled.