Specifications
hg-07.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
7-191
Nur für den internen Gebrauch
Explorers
Payload
WBM path:
WBM > Explorers > Payload > (right-click) Media Stream Control (MSC) > Display MSC Set-
tings
The MSC Settings mask is displayed. For descriptions of the individual fields, see Section
7.7.4.2, "Editing MSC settings".
7.7.4.2 Editing MSC settings
You can edit the current settings for media stream control (MSC).
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Payload
> (right-click) Media Stream Control (MSC) > Edit MSC Settings
The Edit MSC Settings mask is displayed. You can edit the following fields:
● Traffic Statistics (SNMP Only): This field allows you to activate or deactivate "Per Call Sta-
tistics". If the statistics function is deactivated, "Per-Call Statistics" data associated with the
gateway cannot be accessed via SNMP.
● RTCP Packet Generation Interval (sec): Enter the number of seconds after which RTCP
packets are generated in this field.
Click Apply followed by OK in the confirmation mask (save the new configuration status perma-
nently with the Save icon in the control area). The MSC Settings mask reappears.
7.7.4.3 Reset MSC to Factory Settings
You can reset the original settings globally for all MSC settings.
WBM path:
WBM (write access activated with the Padlock icon in the control area?) > Explorers > Payload
> (right-click) Media Stream Control (MSC) > Reset MSC to Factory Settings
The Reset MSC Settings to Factory Settings mask is displayed and contains a warning.
Click Reset to Factory Default and OK in the confirmation mask (save the new configuration
status permanently with the Save icon in the control area).
>
Media stream control should only be reconfigured by specialists. The parameters
available have a complex effect on the transmission quality; a description of these
parameters would exceed the scope of this manual.