Specifications

Wizard Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
5-2 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-05.fm
Initial Setup
● Enhanced B Channels: Select this option if you want to use up to 60 B channels (disabled:
up to 32 B channels).
You cannot use the internal firewall and VPN/IPsec features if you activate the Enhanced
B Channels option. If these features are active, a warning is output when you try to enable
them. The features will be disabled if you confirm this warning with "OK".
● DMC Interworking: This entry indicates if DMC Interworking is active.
● Use Gatekeeper: In this field, select the gatekeeper where the HG 1500 must register. Cis-
co must be set for a Cisco gatekeeper. OpenScape Voice must be set for a gatekeeper in
OpenScape Voice. You can use default for all other scenarios.
Click Apply followed by OK in the confirmation mask and click Next Page to buffer your inputs
and open the dialog for LAN2.
5.1.2 LAN2
Background information:
See Section 9.1, "Environmental Requirements for VoIP"
See Section 9.2, "Bandwidth Requirements in LAN/WAN Environments"
See Section 9.3, "Quality of Service (QoS)"
The dialog display format and input fields are dependent on the operating mode currently active
at the second LAN interface.
● Use the Second LAN as: Select the required operating mode for the second LAN interface.
The following options are available:
– Not configured or deactivated: The second LAN interface should not be used.
– PPTP: If PPTP is activated, an attempt is made to immediately connect to the PPTP
server.
– LAN2: The second LAN interface should be used for direct connection to the LAN. If
you select it, the Dialog for the operating mode: LAN2 is displayed.
– DSL Connection Type PPTP: The second LAN interface should be used for a "Point-
to-Point Tunneling Protocol" DSL connection. An advisory message appears when you
select this option which you must confirm with OK. The Dialog for the operating mode:
DSL Connection Type PPTP is then displayed.
– DSL Connection Type PPPoE: The second LAN interface should be used for a "Point-
to-Point over Ethernet" DSL connection. An advisory message appears when you se-
lect this option which you must confirm with OK. The Dialog for the operating mode:
DSL Connection Type PPPoE is then displayed.