Specifications

hg-05.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
5-3
Nur für den internen Gebrauch
Wizard
Initial Setup
5.1.2.1 Dialog for the operating mode: LAN2
You can make the following entries:
● IP address: Specify the IP address of the interface in this field.
● IP Netmask: Specify the subnet mask in this field.
The MAC address of the board is displayed here for information purposes.
● Ethernet Link Mode: Select the operating mode for the LAN interface:
– Auto: Automatic switching between 10 and 100 Mbps and half duplex and full duplex
mode
– 10HDX: 10 Mbps, half duplex
– 10FDX: 10 Mbps, full duplex
– 100HDX: 100 Mbps, half duplex
– 100FDX: 100 Mbps, full duplex
● Maximum Data Packet Size (Byte): Enter the maximum packet length in bytes that should
apply for this IP protocol. Values between 576 and 1500 are permitted.
● Network Address Translation: Select this option if you want to activate the function for
masking private (internal) IP addresses.
● QoS Capability of Peer: Select one of the possible settings from the context menu:
– Identical: Both "DiffServ" and "IP Precedence" are accepted for the evaluation.
– DiffServ: The transmission partner prefers to work with the evaluation of the "Differen-
tiate Services" 6-bit field (newer procedure).
– IP Precedence: The transmission partner prefers to work with the evaluation of the "IP
Precedence" 3-bit field (older procedure).
● Bandwidth Control for Voice Connections: Bandwidth control prevents the transmission
rates available from being overbooked with voice connections within a multi-link connec-
tion. In other words, when header compression is active, a maximum of five voice connec-
tions (G.729/60 msec or G.723/60 msec) is permitted over a B channel. Select this check
box if you want to activate the "Bandwidth Control for Voice Connections" function. This
function only affects connections from one HG 1500 to another.
● Bandwidth of Connection (Kbps): Enter the bandwidth of the connection in kilobits per sec-
ond.
● Bandwidth Used for Voice/Fax (%): Specify the percentage of bandwidth that should be
used for voice/fax connections.