Specifications
Wizard Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
5-4 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-05.fm
Initial Setup
● IEEE802.1p/q tagging: This option can be used to set the Ethernet format that is sent by
the board. The option is normally deactivated. If you select this function, the following fields
are added to the dialog:
– IEEE802.1p/q VLAN ID: When the IEEE802.1p/q option is active, you can enter a val-
ue that differs from the default value "0" as the VLAN’s ID number if the switch used
has problems with the default value.
– Excellent Effort: Enter a value for the priority of the layer 2 QoS class "Excellent Effort".
Values between 0 and 7 are permitted.
– Controlled Load: Enter a value for the priority of the layer 2 QoS class "Controlled
Load". Values between 0 and 7 are permitted.
– Guaranteed Service: Enter a value for the priority of the layer 2 QoS class "Guaran-
teed Service". Values between 0 and 7 are permitted.
– Network Control: Enter a value for the priority of the layer 2 QoS class "Network Con-
trol". Values between 0 and 7 are permitted.
Click Apply, then select Next Page to buffer your inputs and open the dialog for Codec Parame-
ters.
5.1.2.2 Dialog for the operating mode: DSL Connection Type PPTP
You can make the following entries:
IP Parameters
● Remote IP Address of the PPP Connection: Enter the IP address of the remote end of the
PPP connection in this field. If this PPP connection is used for Internet access, this entry
is only necessary if the Internet Service Provider uses a static IP address.
● Local IP Address of the PPP Connection: Enter the IP address of the local HXG3 board in
this field. If this PPP connection is used for Internet access, this entry is only necessary if
the Internet Service Provider assigned you a static IP address.
● Maximum Data Packet Size (Byte): Enter the maximum packet length in bytes that should
apply for this IP protocol. Values between 576 and 1500 are permitted.
● Negotiate IP Address: Specify if connection partners have to negotiate the IP address at
connection setup.
>
The interface partners must be identically configured to guarantee LAN functionality.