Specifications

hg-05.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
5-5
Nur für den internen Gebrauch
Wizard
Initial Setup
General PPP Parameters
● Default Router: Activate this option if you want to use the DSL connection configured here
as a routing destination. Please note that you can only have one default router: this is either
the DSL access configured here or an individual PSTN peer – see also Section 7.4.4,
"PSTN".
● Internet Access with DNS Request: Specify if you want to use the access for Internet ac-
cess. Note that only one Internet access may be activated per HiPath 3000/5000 V8 - HG
1500 V8 (either one PSTN peer or one DSL connection).
● Name of the Internet Service Provider: Enter a name of your choice here with which you
can identify the ISP.
● PPP Default Header: Specify whether the "default header" should be transferred for the
recipient.
● IP Header Compression: Specify whether TCP headers should be compressed. UDP and
RTP headers are always compressed.
● Send LCP Echo Request: Specify if an LCP echo request should be sent. This function is
used to check if the connection is still active.
● Automatic PPP Connection: Specify if the PPP connection should be automatically estab-
lished at system startup.
● Automatic PPP Reconnection: Specify if the PPP connection should be automatically re-
established after a connection cleardown (for example, in the case of ISP access with flat
rate and forced cleardown after 24 hours).
PPTP Parameter
● Local IP Address of the Control Connection: Enter the IP address of the HiPath HG 1500
used for PPTP connections. The default value is 10.0.0.140. The addresses 0.0.0.0 and
255.255.255.255 are not allowed.
● Remote IP Address of the Control Connection: Enter the IP address of the host computer
to which the PPTP connection should be established. The default value is 10.0.0.138. The
addresses 0.0.0.0 and 255.255.255.255 are not allowed.
● Remote Netmask for the Control Connection: Enter the netmask for the PPTP connection
in this field.
Short Hold
● Short Hold: Select this check box if you want to activate the "Short Hold" function.
● Short Hold Time (sec): Enter the inactivity timeout after which the connection should be
cleared down. The connection will be reestablished automatically as soon as new data
packets are received. The short-hold timer is only triggered by outgoing packets.