Specifications

The CLI Command Interface Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
D-6 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-d.fm
Configuration
Operating mode
The following command can be used to determine the board’s current operating mode:
show mode
D.4 Configuration
This includes commands for configuring the gateway, transferring files, and restarting.
D.4.1 Installation Commands
To perform the initial configuration you must connect a terminal to the V.24 interface of the gate-
way. You can enter the IP address and load the software image from a TFTP server via this
terminal.
Assigning an IP address to the gateway
You must assign a name, an IP address and a subnet mask for the Ethernet interface to the
gateway.
Once it has been entered, the gateway name will be the first element in every command
prompt. Any changes to the IP address or subnet mask will only become effective after the
gateway is restarted.
To change this information, enter:
set hostname <host name>
set ip address <IP address>
set ip subnet <IP subnet mask>
Assigning a default router
You must assign a default router to the gateway.
To assign a default router, enter:
set default gateway <IP address>
D.4.2 Configuration Commands
The gateway has a TFTP client for file transfer purposes. A corresponding TFTP server must
be available in the network. The software image and configuration data are downloaded directly
to the flash memory. Configuration data, trace files and event logs can be loaded from the gate-
way onto the server.