Specifications

hg-d.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
D-7
Nur für den internen Gebrauch
The CLI Command Interface
Configuration
Specifying the primary TFTP server
Before you can load files to the gateway or on the server via TFTP, you must select a TFTP
server using the following command:
set tftp <IP address[:port]>
Specifying the alternative TFTP server
In addition to the primary TFTP server, you can specify an alternative TFTP server with the fol-
lowing command:
set alternate tftp <IP address[:port]>
Switching from the alternative to the primary TFTP server
If the alternative TFTP server has been active and you want to switch back to the primary TFTP
server, use the following command to change TFTP servers:
activate tftp
Switching from the primary to the alternative TFTP server
If the primary TFTP server has been active and you want to switch back to the alternative TFTP
server, use the following command to change TFTP servers:
activate alternate tftp
Downloading software images
You can download a software image from a TFTP server to the gateway by entering:
download software <remote filename>
Enter the following command to conclude the software image switchover:
activate software
During this restart you will be asked if the gateway should be completely reinstalled (deleting
the flash memory and reinitializing it) or if an update should be performed (replacing the exist-
ing files without modifying the configuration).
A complete reinstallation results in an empty database with only one software image in the
gateway. All previous configuration data is lost.
>
This choice is only available if the software was downloaded from a V.24 terminal.