Specifications

The CLI Command Interface Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
D-8 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-d.fm
Configuration
If an update is performed, the currently active software image is replaced by the new image
which is then used at the next reboot.
Loading a configuration onto the server
The following command copies the current configuration file to the TFTP server.
upload configuration <remote filename>
Downloading, activating and saving a configuration from the server
This command copies a configuration file from the TFTP server to the gateway’s flash memory:
download configuration <remote filename>
Execute the following command to activate the new configuration file:
activate configuration
The downloaded configuration file replaces the configuration file in the flash memory. Once the
command activate configuration has been executed, the new configuration is active.
Execute the following command to save the new configuration:
save configuration
This command transfers the new configuration from the RAM to the flash file system, after
which the system is restarted.
TFTP
In addition to the special commands described above, you can also access the TFTP server
directly. This is particularly useful for reading trace and event logs. Binary data transfers are
supported.
The put tftp command transfers files from the gateway to the server; get TFTP transfers
files from the server to the gateway:
get tftp <remote filename> [<local filename>]
put tftp <remote filename> [<local filename>]
To load trace or event logs on the server, enter:
upload trclog <remote filename>
upload evtlog <remote filename>
>
For security reasons, HiPath HG 1500 can only operate as a TFTP client. The TFTP
server must be set up on the partner device.