Specifications

The CLI Command Interface Nur für den internen Gebrauch
A31003-H3580-M103-2-76A9, 01-2009
D-10 HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
hg-d.fm
Maintenance
Interface statuses
The following commands display information on status of the interfaces:
show if counters
show if states
Displaying the IP address, name or subnet mask of the gateway
To view the gateway name, IP address or subnet mask, enter:
show hostname
show ip address
show ip subnet
Information on the active TFTP server addresses
To display the IP addresses of the primary and alternative TFTP server and to check which
server is currently active, enter:
show tftp
Default router information
A default router must be assigned to the gateway.
To view the IP address of the current default router:
show default gateway
Viewing static route entries
To view the entries for static routes, enter:
show route
Showing the operating mode
To display the board’s current operating mode, enter:
show mode
ping
This command sends an ICMP ECHO_REQUEST packet to another device in the network.
ping <IP address>