Specifications

hg-d.fm
A31003-H3580-M103-2-76A9, 01-2009
HiPath 3000/5000 V8 - HG 1500 V8, Administrator Documentation
D-13
Nur für den internen Gebrauch
The CLI Command Interface
Start command line
OU=<use>, CN=<name>“, where <country> is specified with two characters, for example,
EN or num.num.num.num for an IP address
<CRL distr. point> CRL distribution point, URL specification.
Example
create ssl certificate hxg3 1 “C=DE,O=Siemens,OU=Test,CN=Pattern“
2003/01/01/00:00:00 2003/02/01/00:00:00
The fingerprint of the generated certificate is displayed.
This fingerprint is important for checking the generated certificate at a later time. Only an un-
modified certificate shows exactly the same fingerprint.
To view the certificate fingerprint at a later time, enter:
show fingerprint
D.6.2 Enabling and Disabling IPsec
If you have acquired a license for the IPsec function and the SSL function is activated, you can
enable or disable the IPsec function with the following commands:
enable ipsec
disable ipsec
The following command is available for disabling the integrated firewall:
disable firewall
D.7 Start command line
The start command line has a separate command set with which you can control and influence
the startup of the gateway.
>
If you wish to use a blank space in a parameter, then you must place this parameter
in inverted commas. Example: “hxg 3“.
>
A safety message appears when WBM is started after creating a new server certifi-
cate via CLI. View the certificate data and compare the fingerprint of the used cer-
tificate with the fingerprint of the certificate you generated. Only if the two finger-
prints are identical is the certificate unmodified and you can accept it (for details, see
Section 7.2.6.1, "Initial Configuration and Activation of SSL").